Fold-Over Fix

Author:
Publish date:
presented-by
Large 10- to 12-gauge butt connectors? Much finer wire? Try this trick and keep right on chuggin’.

Large 10- to 12-gauge butt connectors? Much finer wire? Try this trick and keep right on chuggin’.

Ever come to the end of a project, almost but not quite? Say, on a Sunday afternoon? When all or most of the stores and chandleries are either closed or too far away? And you’re just one small component away from triumphantly concluding the installation of that new spin-on filter system, gas detector or electric ventilator?

Here’s a nifty little trick if the hang-up has something to do with compatibility issues arising between electrical wire size and the size of the butt, spade, disconnect or snap-plug-type electrical connectors you have in your toolbox. You know, where the wire you’re working with is, let’s say, 16 gauge and the only connector sizes you have in stock are considerably larger and strictly applicable to wire sizes between 12 and 10 gauges only. What to do?

Simply strip about double the normal amount of insulation off the 16-gauge wire and fold it back upon itself as tightly as possible (see photos). Then roll the fold-over between your thumb and forefinger like a pencil in order to produce as much uniformity of diameter as possible. What happens is that you effectively double the thickness of the 16-gauge wire, which you are then going to insert into the business end of the much larger 10- or 12-gauge connector.

Once you’ve squeezed the fold-over into the connector in the more-or-less normal manner, go ahead and crimp the connector using the size-appropriate portion of the crimping tool. It doesn’t hurt to bear down a little harder than you normally would to make sure you’ve got a tight fit. The use of heat-shrink connectors adds to the thoroughness of the fit, of course.

While this strategy works on a range of wire sizes, attempting to use it on wires and connectors that evince truly significant differences in diameter is not advisable. As with most other things, let common sense prevail here.

See more Boatyard Tips here ▶

presented-by

Related

2666808_1500.30112018100014

Diesel fuel filters: Which should you choose?

If you want your diesel engine to run properly, you need the right fuel filters.

KD-Dive-Paint-application

This Antifouling Coating Creates a ‘Liquid Surface’

If mussels foul your boat or dock on a regular basis, you might think the mollusk is the enemy.

~1000-MIDNIGHT-STAR-June-2018

Wrap It Up

To change up the look of your boat, consider the benefits of a vinyl wrap.

2016-Carver-C50-anchor-1187_1800

Get Grounded

Two of the hardest-working pieces of gear on any boat are the anchor and windlass. With a bit of TLC, they’ll work reliably for years.

iStock-650347648_1800

Fill Her Up?

It used to be common to fill fuel tanks before storing your boat for the winter, but that was before ethanol-spiked gasoline.

iStock-120672178_1800

Bottom Check

When your boat’s on the hard, use the opportunity to check below the waterline. Here’s what to look for.

NSR-190413-0147563W16_1800

Get the Air Out

Did air get into your diesel’s fuel system? Here’s how to get going again.